Enter your Flipper Zero bridge API key to access the scanner dashboard. Your key is stored locally in this browser only.
🛡 On your home network the key is fetched automatically. Key is stored locally in your browser only.
📻 Listens on 433.92 MHz for up to 30 seconds. Point a garage door remote, gate fob, car key, or 433 MHz sensor at the top of the Flipper, then click Scan. Captured signals can be replayed.
🪪 NFC CLI is limited in firmware 1.2.0. To scan: hold an NFC card or phone against the back of the Flipper and read it using the NFC app on the Flipper screen. Then click Scan here — it will read the most recently saved card file.
🔑 Reads 125 kHz low-frequency RFID cards (EM4100, HID, etc.) for up to 30 seconds. Hold a key fob, access card, or animal tag against the back of the Flipper, then click Scan.
📡 BLE advertisement scanning is not available via the Flipper CLI. This returns the Flipper's own Bluetooth radio information (HCI version, MAC address). To scan nearby BLE devices, use the Bluetooth Scanner app on the Flipper screen.
📺 Captures infrared signals for up to 30 seconds. Point any IR remote (TV, AC, projector, etc.) at the top of the Flipper and press a button on the remote, then click Scan. Captured signals can be replayed.
📡 Your Flipper has the ESP32 WiFi Marauder app installed. WiFi scanning runs through the Marauder app on the Flipper screen — the app UI doesn't pipe results back to the CLI. Open the ESP32 WiFi Marauder app on your Flipper (Apps → GPIO) to scan networks. Click Scan below to check for any saved scan results.